Control Bay View - Studer Vista 5 M2 Operating Instructions Manual

Vista Digital Mixing System
A.1.3

Control Bay View

6 Software V4.2
By clicking into the fader area of one of the fader bay icons (Faderbay
1...), the ten corresponding faders are shown instead of the Vistonics
screen. The central fader on the right is then hidden. The lower part of the
selected fader bay icon is highlighted – in order to make clear which bay
the operator is looking at.
The hardware keys and buttons (also the keys next to the rotary encoder
Operation
knobs) on the screen can be operated by clicking on them either with the
right or left mouse/trackball buttons.
Rotary encoder knobs can be operated by clicking-and-holding them with
the left mouse/trackball button (this corresponds to touching the real en-
coder knob on the desk surface); the parameter value is then underlined and
displayed below the label area in addition. By moving the mouse or track-
ball to the right or upwards (or anything in-between) the parameter value is
increased; by moving it to the left or downwards (or anything in-between)
the parameter value is decreased.
The control bay view can be selected from the desk overview area at the
bottom of the screen. By clicking into the meter area of the control bay
icon (Controlbay 1), the corresponding Vistonics view opens up, as shown
below. The upper part of the selected control bay icon is highlighted in or-
der to make clear which bay the operator is looking at.
The SECTION navigator changes to the four-FADER PAGE navigator
used in the control bay view. The global Vistonics VIEW selector of the
control bay is shown next to the central fader.
SW V4.2 Date printed: 17.03.10