Isolate - Studer Vista 5 M2 Operating Instructions Manual

Automation Menu:
Entering TRIM RECORD:
5.6.4

Isolate

ISOLATE Rules:
Date printed: 27.08.03
<Option> • With <Disable Trim Replay> checked on the Misc Options page, the
offset of fader Read Mix Data using Trim Replay Data is defeated and
untrimmed audio is heard (also refer to
• Selecting "Clear TRIM Replay Data" from the Automation menu in the
GC deletes the fader Trim Replay Data and creates a new Mix Pass
with 0 dB recorded as the new Trim Replay value.
Controls in TRIM ENABLE can change to TRIM RECORD using any of
the following 3 methods:
1. Local Touch (Touching the control on the Channel Strip), CGM
Touch, or (D950 only) CAS Touch. TOUCH RECORD engaged or
the AUTO MODE modifier key must be used.
2. Local punch-in using the Channel Strip STAT (record punch) key.
3. Global punch-in via Global Record Punch In key, or Auto-Punch,
or GPI (refer to
ISOLATE is the system's manual mode. Controls in ISOLATE neither re-
sponds to or creates new mix data. In other words, the control is essentially
removed from the automation system is becomes strictly a manual control.
Note: A control in ISOLATE mode differs from a Static control in regard that
changes in an Isolated control's position are not written to Mix Passes.
Likewise, Static values are not applied to Isolated controls.
Record Off:
• ISOLATE: The control acts like a manual control and is unaffected by
any previously written Read and Trim Replay data.
- The audio follows the control position
Record On:
• A control in ISOLATE cannot be placed into record.
SW V3.3
D950/Vista7 Digital Mixing System
chapter
chapter 5.8.5).
5.21.8).
AutoTouch+ 5-49