Studer Vista 5 M2 Operating Instructions Manual page 184

Vista 5 Digital Mixing System
4-74 GC Operation
The chosen Bus Owner channel is shown in the list as
Ext Line 5), any assigned channels to the bus are shown in the list as
(e.g. Inp m 8).
Clicking on individual channel boxes will either select or deselect a channel;
this makes the N–1 bus in fact being an N–x bus. It is also possible to mark
a number of channels to be assigned by left-clicking and dragging across a
number of channels for speed.
It is also possible to assign channels to a confi gured N–1 bus by using the bus
assign window on the control surface.
The talkback and N–1 bus level control will be displayed in the assigned
channel strip for the N–1 Bus Owner Channel.
The right-hand bargraph channel meter for the Bus Owner Channel will
automatically show the N–1 bus level output.
Tip The N–1 settings are saved within snapshots.
Option to bring back ALT N–X status upon closing fader
Option active (
the fader again, in case it was active before opening. This allows e.g. feeding
an off-air signal to the outside lines while there are not on air (e.g. output
signal from on-air console including commercials). Result: When the fader
is opened, the outside lines get the normal N–X signal; when closed they are
switched to the off-air signal (also
SW V3.6
) : The signal will switch back to ALT N–X upon closing
refer to chapter
(in our example,
4.9.7.8).
Date printed: 06.12.06