Cue List Options - Studer Vista 5 M2 Operating Instructions Manual

Digital mixing system, sw v4.5

Hide thumbs Also See for Vista 5 M2:

Table of Contents

Vista 5 Digital Mixing System

Cue List Options

Default Crossfade Options:

Switch Options:

Default Crossfade Time:

Enable Trim Mode:

Enable Partial Snapshots:

4-112 GC Operation

In the "Option - Snapshot Automation Options" menu the following options

are available:

The system allows cross-fading between two cues. The default cross-fade

values may be deﬁ ned here. These will be used whenever a new cue is crea-

Describes the behavior of switches (e.g. MUTE, EQ on/off etc.) when cross-

fading. They apply if a switch changes its state in the next cue. They may

change their state before, during, or after the cross-fade.

Set default value of cross-fades when new cues are created.

When pressing-and-holding the ISO key on the channel strip followed by

touching individual controls (e.g. faders, rotaries), their state can be isolated

from snapshot recalls. If this option is on, the particular parameter may be

touched a second time. This will set it into Trim mode. In this mode all chan-

ges to that parameter since the last snapshot recall will be applied relative (!)

to all upcoming snapshot recalls – thus, not modifying them on disk.

Activates the "Partial Snapshot" feature. It will be possible to include only

ganged channels when making a snapshot. Options are available within the

snapshot window of the GC screen.

Date printed: 06.12.06

Table of Contents