Studer Vista 5 M2 Operating Instructions Manual page 238

Vista 5 Digital Mixing System
Files Used to Save Pro-Bel Set-up
Example for a .Pro-Bel File
4-128 GC Operation
The system creates human-readable fi les (ini format) in the D950System
directory to save the set-up. The fi les are named according to the COM port
used: PortX.Pro-Bel – with X being the COM port used.
[TARGET_1 SOURCE_6]
Im23 Inp m 23 In1 left=D12L AES B 1 In4L left
Im24 Inp m 24 In1 left=D12L AES B 1 In4L left
[TARGET_1 SOURCE_7]
Im23 Inp m 23 In1 left=D11R AES B 1 In3R left
Im24 Inp m 24 In1 left=D11R AES B 1 In3R left
[TARGET_1 SOURCE_4]
Im23 Inp m 23 In1 left=
Im24 Inp m 24 In1 left=
[TARGET_0 SOURCE_0]
Im23 Inp m 23 In1 left=D11R AES B 1 In3R left
Im24 Inp m 24 In1 left=D11R AES B 1 In3R left
Im25 Inp m 25 In1 left=
Im26 Inp m 26 In1 left=
This fi le basically has a section for each used Source/Target combination. The
fi xed labels are being used; "left" is appended for left or mono sources/targets,
and "right" is appended for right sources/targets.
Alternatively a short form of this fi le may be used in order to support the
standard case where all combinations of certain inputs and outputs should
be under control of an external device, there is a new fi le format introduced
allowing to only list the required inputs and outputs.
The alternate fi le format looks as follows:
[TARGETS]
1=i 1 B 1 Ch 1 left
[SOURCES]
1=I 1 B 1 Ch 1 left
This example defi nes Pro-Bel destination 1 to be "i
and Pro-Bel source 1 to be "I
fi xed label syntax.
The format is:
destination|source=fi xed label of patch element + left
The appended " left" is kept on purpose in order to keep both formats
compatible.
Note: If a source or destination is listed twice by accident, once in the simple format
and once in an x/y combination, the simple format has priority, and the x/y
listing isn't recognized. This situation is regarded as an error and should not
occur in regular cases.
SW V3.6
1" output interface
1" output interface using the patch points
Date printed: 06.12.06