Skoda Octavia Owner's Manual page 168

Note
If you lose the key, please get in touch with a specialist garage.
Adjusting the ready position
Fig. 161 1st Step: Key Version 1 / key Version 2

Read and observe and
Always adjust before setting the coupling ball bar in the ready position in the
following two steps.
1st Step - applies to the key version 1
›
Turn the key in the direction of
A
1st Step - applies to the key version 2
›
Turn the key in the direction of arrow
shows up » Fig. 161.
2nd Step - applies to both key versions
›
Grip the tow bar below the protective cap.
166
Driving
Fig. 162
2nd Step: both key versions
on page 165 first.
so that its red mark is visible
1,
so that the conclusions release
B 2
›
Push the trigger pin
the lever in direction of arrow
D
The lever remains locked in this position.
Adjusting the ready position
Fig. 163 Ready position: Key Version 1 / key Version 2 / position of the
lever and the release bolt with two key versions

Read and observe
Correctly adjusted standby position
Applies to the key Version 1 - key

mark is visible).
Applies to the key Version 2 -, the

conclusions release shows up).
The lever is located in the lower position.
C

The trigger pin

The ball bar is thus set ready for installation.
CAUTION
In the ready position, the key cannot be removed nor turned into a different
position.
» Fig. 161.
in the direction of arrow
C 3
to the stop » Fig.
4
and on page 165 first.
» Fig. 163
is in the unlocked setting (its red
A
key is in the unlocked setting (the
B
can be moved.
D
and simultaneously push
162.