Skoda Octavia Owner's Manual page 152

Stop/resume control

Read and observe and
Stop control
›
Set the lever into the sprung position 
or
›
Apply the brake.
Control stops, the speed remains stored.
Resume control
›
Start control » page 149.
WARNING
Control may only be resumed if the stored speed is not too high for the cur-
rent traffic conditions.
Note
Control is also stopped when the clutch is held down for longer than 30 s.
Set/change the desired speed

Read and observe and
The desired speed can be set or changed using the control
The set speed is stored upon releasing the lever or the button on the button
on the lever.
Set/change speed by 10 km/h at a time) - Requirements
ACC is enabled.

Increase speed by 1 km/h at a time () - Requirements
ACC is enabled.

Vehicle control ensues.

Decrease speed by 1 km/h at a time () - Requirements
ACC is enabled.

Vehicle control ensues.

150
Driving
on page 146 first.
» Fig. 147 on page 149 .
on page 146 first.
lever» page
Change speed by adopting the current speed) - Requirements
ACC is enabled.

The vehicle is moving at a speed other than that which is stored.

Note
If during control the speed is increased by pressing the accelerator, control is
■
temporarily stopped. Upon releasing the accelerator, control is automatically
resumed.
If during control the speed is reduced by applying the brake, control is stop-
■
ped. Control needs to be restarted in order to resume
If the vehicle is controlled by a lower speed than the stored speed, then 
■
the current speed is stored by the first press of the button , press the button
again  and the speed is reduced in increments of 1 km / h.
Set time interval level

Read and observe
The proximity to the vehicle ahead can be set with the lever
page 149 or in Infotainment
(CAR button).
Setting by means of the lever
›
Set the switch  in the sprung position
page 149 .
149.
The display of the instrument cluster shows line
which indicates the proximity.
›
Using the switch  on the lever, adjust line
level.
Note
If the proximity is changed in infotainment, the change will only come into
■
effect after a subsequent activation of the ACC.
The proximity is dependent on the speed. The higher the speed, the greater
■
the proximity to the vehicle ahead.
On wet roads, a longer time interval to the vehicle ahead should always be
■
selected than on dry roads.
» page
and on page 146 first.
» infotainment manual, chapter Vehicle settings
or to adjust
-

» Fig. 145
2
to the desired proximity
2
149.
» Fig. 147 on
» Fig. 147 on
on page 148,