WARNING (Continued)
Check the tyre inflation pressure after driving for 10 minutes.
■
The sealant is hazardous to heath. Remove immediately if it comes into
■
contact with the skin.
Observe the manufacturer's usage instructions for the breakdown kit.
■
For the sake of the environment
Used sealant or sealant whose expiry date has passed must be disposed of in
accordance with environmental protection regulations.
Note
A new bottle of sealant can be purchased from ŠKODA Original Parts.
■
Immediately replace the tyre that was repaired using the breakdown kit, or
■
consult a specialist garage about repair options.
Breakdown kit
Fig. 200 Principle sketch: Components of the breakdown kit
Read and observe
on page 213 first.
The kit is located in a box under the floor covering in the luggage compart-
ment.
Components of the breakdown kit
Sticker with speed designation "max. 80 km/h"/"max. 50 mph"
1
Valve remover
2
214
Do-it-yourself
» Fig. 200
Inflation hose with plug
3
Air compressor
4
Button for releasing the tyre pressure
5
12 volt cable connector
6
Tyre inflation hose
7
Tyre inflation pressure indicator
8
ON and OFF switch
9
Tyre inflator bottle with sealing agent
10
Replacement valve core
11
The valve remover
has a slot at its lower end which fits into the valve core.
2
Preparations for using the breakdown kit
Read and observe
on page 213 first.
Always change a wheel on a level surface as far as possible.
The following preparatory work must be carried out before using the break-
down kit.
›
Have all of the occupants get out of the vehicle. While changing a tyre, the
occupants of the vehicle should not stand on the road (they should instead
remain behind a crash barrier).
›
Switch off the engine.
›
Move the gearshift lever into Neutral or move the selector lever for the auto-
matic gearbox into position P.
›
Firmly apply the handbrake.
›
Check that you can carry out the repairs with the breakdown kit
›
Uncouple any trailers.
›
Remove the breakdown kit from the luggage compartment.
›
Stick the sticker
» Fig. 200
on page 214 on the dashboard in the driver's
1
field of view.
›
Do not remove the foreign body, e.g. screw or nail, from the tyre.
›
Unscrew the valve cap.
›
Use the valve remover
to unscrew the valve core and place it on a clean
2
surface (rag, paper, etc.).
» page
213.