Check that the light is securely inserted.
Rear Light
Fig. 226 Remove light / pull out connector
Read and observe
and
Removing
›
Open the tailgate.
›
Insert into opening
» Fig. 226
A
1)
ers
» page
208, Vehicle tool kit .
›
Remove the cover by pulling the hook in the direction of arrow
›
Unscrew the screws
with the key from the tool kit.
B
›
Grasp the light and carefully remove with shaky movements in the direction
of arrow
.
2
›
Press together the interlocks on the connector
1)
The position of the opening may vary depending on the vehicle model.
2)
The design of the plug can vary depending on the vehicle equipment.
on page 227 first.
the clamps for removing the full wheel cov-
in the direction of arrow
2)
›
Carefully remove the connector from the tail lamp assembly in the direction
of the arrow
Fitting
›
Insert the bulb holder in the light.
The locks on the plug must be inserted securely.
›
Insert the lamp with the pin
» Fig. 226
C
›
Carefully push the cover in
›
Screw the tail lamp into place and install the cover.
The cover must engage securely.
CAUTION
Ensure that the cable bundle does not become pinched between the body
■
and the lamp when it is being refitted – risk of damage to the electrical instal-
lation and risk of water ingress.
If you are not sure whether the cable bundle has become pinched, we recom-
■
mend that you have the light connection checked by a specialist garage.
Ensure that the vehicle paintwork and the tail lamp are not damaged when
■
removing and installing the tail lamp.
Replacing bulbs in the rear light - Variant 1
.
1
Fig. 227 Outer part of the light: Basic light/light with LED diodes
.
3
.
4
» Fig. 227
on page 231 into the recesses
A
in the body.
»
.
231
Fuses and light bulbs