›
Have all of the occupants get out of the vehicle. While changing a tyre, the
occupants of the vehicle should not stand on the road (they should instead
remain behind a crash barrier).
›
Switch off the engine.
›
Move the gearshift lever into Neutral or move the selector lever for the auto-
matic gearbox into position P.
›
Firmly apply the handbrake.
›
Uncouple any trailers.
›
Remove the vehicle tool kit
» page 208
from the boot.
Full wheel trim
Read and observe
on page 209 first.
Extracting
›
Hook the clamp found in the vehicle tool kit
edge of the wheel trim.
›
Push the wheel wrench through the clamp, support on the tyre and pull off
the wheel trim.
Installing
›
Press the wheel trim onto the wheel rim at the designated valve open-
ing
»
.
›
Then press the trim into the wheel rim until its entire circumference locks
correctly in place.
CAUTION
When using an anti-theft wheel bolt, make sure that this has been fitted ac-
■
cording to the position marked on the back of the wheel cover position.
On the back of the wheel cover, the position for the anti-theft wheel bolt is
■
marked by means of a symbol. If the wheel cover is set outside the position
marked for the anti-theft wheel bolt, there is a risk of damaging the wheel
cover.
Use the pressure of your hand only, do not strike the full wheel trim. The
■
cover could be damaged.
If wheel trims are fitted, it must be ensured that an adequate flow of air is
■
assured to cool the brake system. We recommend that you use child seats
from ŠKODA Original Accessories.
210
Do-it-yourself
and the spare wheel
» page 205
» page 208
into the reinforced
Wheel bolts
Read and observe
on page 209 first.
Extracting
›
Push the extraction pliers
» page 208
inner catches of the pliers are positioned at the collar of the cap.
›
Remove the cap in the direction of the arrow
Fitting
›
Push the cap onto the wheel bolt up to the stop.
The wheel bolt caps are housed in a plastic box in the spare wheel or in the
storage space for the spare wheel.
Changing a wheel
Read and observe
on page 209 first.
›
Remove the full wheel trim or the caps of the wheel bolts.
›
First of all slacken the anti-theft wheel bolt and then the other wheel bolts.
›
Jack up the vehicle until the wheel that needs changing is clear of the
ground.
›
Unscrew the wheel bolts and place them on a clean surface (cloth, paper,
etc.).
›
Remove the wheel carefully.
›
Attach the spare wheel and slightly screw on the wheel bolts.
›
Lower the vehicle.
›
Tighten the wheel bolts opposite each other using the wheel wrench (alter-
nating crosswise). Tighten the anti-theft wheel bolt last.
›
Replace the wheel trim or the caps.
Fig. 193
Remove the cap
sufficiently far onto the cap until the
» Fig.
193.