Getting Started; Installing The Configtool Ip Utility - Honeywell Performance HED1PR3 Software Configuration Manual

Getting Started

This chapter contains the following sections:
•
•
•
•
•

Installing the ConfigTool IP Utility

Before you can start using your camera, you must install the ConfigTool IP utility on your PC.
1.
2.
3.
4.
5.
6.
Installing the ConfigTool IP Utility, page 27
Discovering Your Device on the Network, page 28
Assigning a New IP Address to Your Device, page 28
Upgrading Your Device's Firmware, page 29
Opening a Web Client, page 31
Insert the software CD that came with your camera into your PC's disk drive.
Open the Honeywell Config Tool folder, and then double-click Honeywell ConfigTool.exe.
On the ConfigTool welcome screen, click Next.
Read the User License Agreement. If you agree, select I agree.
If you want, you can change the installation directory (by default, ConfigTool will be installed
in C:\Program Files). To proceed with the installation, click Install.
If the installation is successful, the message "Installation is complete!" appears.
Click Enjoy Now to open ConfigTool.
2
2
800-21358 - A - 10/2015