Adjustment Of 1St And 2Nd Scanner Alignment - Ricoh K-C1 Service Manual

20 February, 2001

3.4.10 ADJUSTMENT OF 1ST AND 2ND SCANNER ALIGNMENT

For how to use this procedure, see the previous section, 'Adjustment of 2nd
Scanner Position'.
[D]
[C]
[B]
1. Remove the A(R)DF or platen cover.
2. Remove the operation panel (☛ 3.3.5).
3. Remove the top rear cover (☛ 3.3.7).
4. Loosen the 2 screws [A] holding the 1st and 2nd scanner belts in place.
5. Slide the 1st and 2nd scanners so that all three of the following are aligned on
both sides:
• The second hole from the right on each 2nd scanner arm
• The position guide holes on the upper and lower mainframe rims
• The 1st scanner position guide hole [B]
6. Insert the positioning tools [C] into both sets of holes.
7. Make sure that both the 1st and 2nd scanner belts are properly set in place on
both sides [D].
8. Re-tighten the screws loosened in step 1 [A] to clamp the scanner belts in
place, then remove the positioning tools.
[A]
3-17
SCANNER SECTION
[C]
[B]
[A]
B039R007.WMF