Ricoh K-C1 Service Manual page 138

USING SERVICE PROGRAM MODES
7
Mode Number/Name
801 Memory/Version/PN
1 Main P/N
2 Main version
3 Fax P/N
4 Printer P/N
5 ADF ROM
6 Copier memory
7 # optional trays
803* Display – PM Counter
804 Reset – PM Counter
807 Reset – SC/Jam Counters
808 Reset – Counters
810 Reset – Key Operator Code
Function/[Setting]
Displays the P/N and suffix of the copier firmware.
Displays the version of the BiCU board
Displays the P/N and suffix of the fax firmware.
Displays the P/N and suffix of printer firmware.
Displays the P/N and suffix of the ADF ROM.
Displays the total amount of copier memory installed.
Displays the number of optional paper trays currently
installed.
Displays the PM counter value (since the last PM).
Resets the PM counter.
[0 = No / 1 = Yes]
After selecting "1", press the Original Type key and the
OK key (or ' key) at the same time to execute the reset.
If the reset is successful, the display shows "Action
completed." If the reset fails, the display shows "Error!!!".
Resets the SC, paper, original, and total jam counter
values.
[0 = No / 1 = Yes]
After selecting "1", press the Original Type key and the
OK key (or ' key) at the same time to execute the reset.
If the reset is successful, the display shows "Action
completed." If the reset fails, the display shows "Error!!!".
Resets all counters except for the total print counters
(SP7-003) and timer counter (SP7-991).
[0 = No / 1 = Yes]
After selecting "1", press the Original Type key and the
OK key (or ' key) at the same time to execute the reset.
If the reset is successful, the display shows "Action
completed." If the reset fails, the display shows "Error!!!".
Resets the key operator code.
[0 = No / 1=Yes]
• After selecting "1", press the Original Type key and the
OK key (or ' key) at the same time to execute the
reset. If the reset is successful, the display shows
"Action completed." If the reset fails, the display shows
"Error!!!".
• If the customer forgets the key operator code, clear it by
using this SP mode and re-input the code using: [2.
System Settings] → [13. Key Operator Tools] → [14.
Program Key Operator Code].
5-28
20 February, 2001