Ricoh K-C1 Service Manual page 129

20 February, 2001
5
Mode Number/Name
810 SC Code Reset
811* Serial Number Input
812* Service Telephone Number
1 Telephone
2 Facsimile
824 NVRAM Data Upload
825 NVRAM Data Download
826 Program Upload
USING SERVICE PROGRAM MODES
Function/[Setting]
Resets all level-A service call conditions, such as fusing
errors. (To reset SC 547, switch the machine off/on.)
[0 = No / 1 = Yes]
• After selecting "1", press the Original Type key and the
' key (or OK key) at the same time to execute the
reset. If the reset is successful, the display shows
"Action completed." If the reset fails, the display shows
"Error!!!".
☛ 4.1 Service Call Conditions
Used to input the machine serial number (normally done
at the factory). This is the serial number printed on SMC
reports.
☛ 5.1.13 Serial Number Input
Use this to input the telephone number of the service
representative. (The number is displayed when a service
call condition occurs.)
• To input a dash, press !.
• To delete the current telephone number, press %.
Use this to input the fax number printed on user counter
reports.
• To input a dash, press !.
• To delete the current fax number, press %.
Uploads SP and UP mode data (except for some items
such as counters and the serial number) from the flash
memory on the BiCU board to a flash memory card.
[0 = No / 1 = Yes]
This SP can be used when a flash memory card has been
plugged into the machine's card slot.
☛ 5.1.11 NVRAM Data Upload/Download
Downloads SP mode data from a flash memory card to
the flash memory on the BiCU board.
[0 = No / 1 = Yes]
This SP can be used when a flash memory card has been
plugged into the machine's card slot.
☛ 5.1.11 NVRAM Data Upload/Download
Uploads the system program from the flash memory on
the BICU board to a flash memory card.
[0 = No / 1 = Yes]
This SP can be used when a flash memory card has been
plugged into the machine's card slot.
☛ 5.1.10 Program Upload/Download
5-19