Ricoh K-C1 Service Manual page 135

20 February, 2001
6
Mode Number/Name
910 ADF/Printer Free Run
911* Binding Hole Range
USING SERVICE PROGRAM MODES
Function/[Setting]
Performs a free run for the ADF and printer using a
special ROM.
[0 = No / 1 = Yes] DFU
Selects the diameter of the binding holes in the original
that the sensors will ignore. If set at "0", this function is
disabled.
[0 ~ 20 / 12 / 1 mm/step]
Original jams may occur when feeding originals with
binding holes, because these holes may be detected by
the sensors. Use this SP to avoid this problem. For
example, setting this value to 12 mm will cause the
sensors to ignore binding holes up to 12 mm in diameter.
5-25