Returning To Stand-By Mode - Ricoh K-C1 Service Manual

ENERGY SAVER MODES

Returning to Stand-by Mode

If one of the following is done, the machine returns to standby mode:
• Operation switch is pressed
• An original is placed in the ADF
• The platen cover or ADF is lifted
• The machine receives the wake-up signal from a PC (Smart Net Monitor)
• An error or SC condition occurs
6.15.3 NIGHT/OFF MODE
The machine's behaviour depends on whether a fax or printer option has been
installed.
If no optional fax and/or printer unit is installed, the main power switches off when
the machine enters night/off mode. (This is the same as the Auto Off Mode used in
previous models).
If an optional fax and/or printer unit is installed, the main power does not switch off
when the machine enters night/off mode. The machine enters a watching mode
that is the same as low power mode level 3.
Entering Night/off Mode
The machine enters night/off mode when:
• The auto off timer has expired following the last time engine components or
sensors were active (e.g. end of a copy job, platen cover lifted, key pressed, etc).
User Tools—System Settings—Auto Off Timer
The default setting is 30 min
If the energy saver timer setting is greater than the auto off timer setting, the
machine will enter night/off mode (rather than low power mode) when the auto off
timer runs out after the end of the job.
6-74
20 February, 2001