Nvram Data Upload (Sp5-824) - Ricoh K-C1 Service Manual

USING SERVICE PROGRAM MODES
6. The machine erases the current settings, then writes the new settings onto the
NVRAM on the BiCU board. This takes about 1 second. If downloading fails, an
error message appears (☛ "5.1.9 Program Download"). If the error message
appears, repeat the download procedure.
7. Turn off the main switch, then remove the memory card.

NVRAM Data Upload (SP5-824)

1. Turn off the main switch.
2. Insert a flash memory card into the card slot. (See the previous page.)
NOTE: Make sure that the printed "A" on the card is facing the outside of the
machine.
3. Turn on the main switch.
4. Access SP mode 5-824.
5. The machine erases the settings on the card, then writes the machine's
settings to the flash memory card. This takes about 20 seconds. If uploading
fails, an error message appears (see "5.1.9 Program Download"). If the error
message appears, repeat the upload procedure.
6. Turn off the main switch, then remove the memory card.
5-44
20 February, 2001