Scanner Motor; Scanner H - Ricoh K-C1 Service Manual

20 February, 2001

3.4.7 SCANNER MOTOR

1. Rear cover (☛ 3.3.1)
2. Right upper cover (☛ 3.3.6)
3. Rear scale and exposure glass (☛
3.4.1)
4. Operation panel (☛ 3.3.5)
5. Top rear cover (☛ 3.3.7)
6. Detach the belt [A].
7. Scanner motor [B] (! x 3, 1 spring,
" x 1)
NOTE: When reinstalling the motor:
Fit the belt on first, then set
the spring in place, and then
screw in evenly, rotating from
screw to screw so that the
spring tension is correctly distributed.
After installing the motor, do the copy adjustments (☛ 3.13).
3.4.8 SCANNER H.P. SENSOR
1. Left upper cover (☛ 3.3.4)
2. Top rear cover (☛ 3.3.7)
3. Exposure glass (☛ 3.4.1)
NOTE: If the machine is an A(R)DF
model, remove both the DF
exposure glass and the exposure
glass.
4. Disconnect the scanner H.P. sensor
connector [C].
5. Scanner left lid [D] (! x 7)
6. Remove the sensor tape [E].
7. Scanner H.P. sensor [F]
[A]
[E]
[D]
[F]
3-15
SCANNER SECTION
[B]
B039R008.WMF
[C]
B039R005.WMF