Check Points Of Every 100 Hours - Kubota D1503-M-DI Workshop Manual

03-M-DI Series, WSM

(3) Check Points of Every 100 Hours

Cleaning Air Cleaner Element
1. Remove the air cleaner element.
2. Use clean dry compressed air on the inside of the element.
Pressure of compressed air must be under 205 kPa (2.1 kgf/cm
30 psi).
Maintain reasonable distance between the nozzle and the filter.
NOTE
• The air cleaner uses a dry element. Never apply oil to it.
• Be sure to refit the dust cup with arrow ↑ (on the rear)
upright. If the dust cup is improperly fitted, dust passes by
the dust cup and directly adheres to the element.
• Do not run the engine with filter element removed.
• Change the element once a year or every 6th cleaning.
Cleaning Fuel Filter (Normal Type only)
1. Close the fuel cock (3).
2. Unscrew the retaining ring (6) and remove the cup (5), and rinse
the inside with kerosene.
3. Take out the element (4) and dip it in the kerosene to rinse.
4. After cleaning, reassemble the fuel filter, keeping out dust and
dirt.
5. Bleed the fuel system.
IMPORTANT
• If dust and dirt enter the fuel, the fuel injection pump and
injection nozzle will wear quickly. To prevent this, be sure
to clean the fuel filter cup (5) periodically.
(1) Cock Body
(2) Air Vent Plug
(3) Fuel Cock
Checking Battery Electrolyte Level
1. Check the battery electrolyte level.
2. If the level is below than lower level line (2), and the distilled water
to pour level of each cell.
(1) Upper Level Line
S-21
DIESEL ENGINE
W1045746
(4) Filter Element
(5) Filter Cup
(6) Retaining Ring
W1046058
(2) Lower Level Line
W1047154
KiSC issued 10, 2009 A
2
,