Check Points Of Every 100 Hours - Kubota WG1605-G-E3 Workshop Manual

WG1605-G-E3,WG1605-L-E3,WG1605-GL-E3, WSM

[4] CHECK POINTS OF EVERY 100 HOURS

Cleaning Air Cleaner Element
1. Remove the air cleaner element.
2. Use clean dry compressed air on the inside of the element.
Pressure of compressed air must be under 205 kPa
2
(2.1 kgf/cm , 30 psi).
Keep reasonable distance between the nozzle and the filter.
NOTE
• The air cleaner uses a dry element. Never apply oil to it.
• Do not run the engine with filter element removed.
• Change the element once a year or every 6th cleaning.
Cleaning Spark Plug
1. Remove the spark plug, and remove carbon from the electrode
with a wire brush or other tools.
2. Measure the spark plug gap with a feeler gauge, and adjust or
replace the spark plug if the measured gap differs from the
factory specification.
3. Replace the spark plug if the electrode or the insulator is
deformed or cracked.
4. Tighten the spark plug with a plug wrench.
IMPORTANT
(When reassembling)
• Put the ignition coil inside the spark plug terminal firmly.
• Make sure that the wiring and the ignition coil are correctly
connected.
• Fix the ignition coil by screw / nut.
Spark plug gap Factory specification
Spark plug
Spark plug
Tightening torque
Ignition coil mounting screw
/ nut
Checking Fuel Filter
1. Check the fuel filter.
2. If the fuel filter is dirty, clean it or replace it.
CAUTION
• Stop the engine when trying to check and clean the fuel
filter.
• Gasoline fuel is extremely flammable, so avoid fires.
G-13
GENERAL
9Y1210661GEG0042US0
0.70 to 0.80 mm
0.028 to 0.031 in.
NGK IFR6F8DN
24.5 to 29.4 N·m
2.50 to 2.99 kgf·m
18.1 to 21.6 lbf·ft
9.81 to 11.3 N·m
1.00 to 1.15 kgf·m
7.24 to 8.33 lbf·ft
9Y1210661GEG0044US0
9Y1210318GEG0028US0
KiSC issued 05, 2014 A