Idle Gear, Camshaft, Balancer Shaft Clearance - Kubota D1503-M-DI Workshop Manual

03-M-DI Series, WSM
Idle Gear Side Clearance
1. Set a dial indicator with its tip on the idle gear.
2. Measure the side clearance by moving the idle gear to the front
and rear.
3. If the measurement exceeds the allowable limit, replace the idle
gear collar.
Factory spec.
Idle gear side clearance
Allowable limit
Camshaft Side Clearance
1. Set a dial indicator with its tip on the camshaft.
2. Measure the side clearance by moving the cam gear to the front
and rear.
3. If the measurement exceeds the allowable limit, replace the
camshaft stopper.
Factory spec.
Camshaft side
clearance
Allowable limit
Balancer Shaft Side Clearance (For Balancer Model Only)
1. Set a dial indicator with tip on the balancer shaft.
2. Measure the side clearance by moving the balancer shaft to the
front and rear.
3. If the measurement exceeds the allowable limit, replace the
balancer shaft.
Factory spec.
Side clearance of
balancer shaft
Allowable limit
S-67
DIESEL ENGINE
0.12 to 0.48 mm
0.0047 to 0.0189 in.
0.9 mm
0.0354 in.
W1029843
0.07 to 0.22 mm
0.0028 to 0.0087 in.
0.30 mm
0.0118 in.
W1030012
0.07 to 0.22 mm
0.0028 to 0.0087 in.
0.3 mm
0.0118 in.
W1030111
KiSC issued 10, 2009 A