Disassembling And Assembling - Kubota D1503-M-DI Workshop Manual

03-M-DI Series, WSM

[2] DISASSEMBLING AND ASSEMBLING

CAUTION
• While the engine is running and or just after it stops, the turbocharger is hot, be careful not to touch the
turbocharger.
NOTE
• When detaching and attaching the turbocharger assembly, be very careful not to allow dust, dirt and other
foreign matters in the oil pipes.
• When the turbocharger assembly has been replaced, pour fresh engine oil through the oil filter port of the
turbocharger.
• Before starting the engine, make sure that the air cleaner is in position.
Air Cleaner and Muffler
1. Remove the intake pipe (1).
2. Remove the inlet pipe 1 (2).
3. Remove the muffler (3).
(When reassembling)
• Replace the gasket with new one.
(1) Intake Pipe
(2) Inlet Pipe 1
Oil Pipe
1. Remove the joint bolt (1), (2) and take off the oil pipe 1 (3).
2. Remove the bolts (4) and release the clamp (5).
3. Disconnect the oil pipe 2 (6) and pipe 4 (7).
(When reassembling)
• Pour fresh engine oil through the oil filter port of the turbocharger.
• Replace the gaskets with new one.
• Be careful not to allow dust, dirt and other foreign matters in the
oil pipes.
NOTE
• Tape or plug all opening to prevent foreign matters from
damaging the oil cavities in the turbocharger.
(1) Joint Bolt
(2) Joint Bolt
(3) Oil Pipe 1
(4) Bolt
Turbocharger
1. Remove the bolt (1).
2. Take off the turbocharger assemble (2).
(When reassembling)
• Replace the gasket with new one.
(1) Bolt
S-102
DIESEL ENGINE
(3) Muffler
W1070719
(5) Clamp
(6) Oil Pipe 2
(7) Oil Pipe 4
W1070836
(2) Turbocharger Assemble
W1071031
KiSC issued 10, 2009 A