Unpacking and Parts Identification (Cont)
Verify that you have the following items when unpacking:
2.3 Setting Up the M-5900RV
Consider the following when setting up the printer:
PN 9001081
Rev. C
Printer
Power Cord
Operator's Manual/Programmer and Technical Reference Manual
CD containing Label Wizard SE
Locate a solid flat surface to set the printer. Make sure there is
enough room at the top and right-hand side (facing the printer) to
provide clearance for the right side access door to swing open.
The location should be near the host computer or terminal. The
maximum distance for RS232 cables is 50 feet and six feet for
Centronics Parallel cables. Cables can be purchased locally, and their
configuration will depend upon the host system being used.
.or information on interfacing the printer to a host system, see
Section 5: Interface Specifications.
SATO M-5900RV Operator and Technical Reference Manual
Section 2. Installation and Configuration
Page 2-3