Section 4. Programming Reference Page; Command Default Settings - SATO M-5900RV Operator And Technical Reference Manual

4.7 Command Default Settings

There are some types of commands that must have a value specified before a label
can be printed. If the data stream does not contain these commands, a "default"
value is assumed. The commands and the corresponding default values are:
PN 9001081
Rev. C
COMMAND
Character Expansion
Print Darkness
Print Speed DSW2-8 On
Print Speed DSW2-8 Off
Proportional Spacing
Cutter Command
Print Rotation
Vertical Reference Point
Horizontal Reference Point
Character Pitch
Base Reference Point
NOTES:
(1) The settings for these commands will revert to the default value when the
printer receives an <ESC>Z or an <ESC>*.
(2) The values transmitted with these commands will remain in effect until a new
command is received.
SATO M-5900RV Operator and Technical Reference Manual
Section 4. Programming Reference
DEFAULT
1
2
6 ips
4 ips
Enabled
Disabled
0
0
0
0
2
H=0, V=0
NOTE
(1)
(1)
(2)
(2)
(1)
(1)
(1)
(1)
(1)
(1)
(2)
Page 4-11