Platen - SATO M-5900RV Operator And Technical Reference Manual

Cleaning the Print Head and Platen

Platen

Supplies needed:
SATO SA070 Cleaning Kit (or equivalent)
STEP
1.
2.
3.
4.
5.
6.
Apply SATO Thermal Print
Head and Platen Cleaner
to a clean wipe or cotton
swab and gently wipe
across the entire length of
the platen, rotating to
clean the entire surface
PN 9001081
Rev. C
PROCEDURE
Turn O.. the Power Switch
Raise the printer side door. .ig. Page 3-4
Open the PRINT HEAD ASSEMBLY by pulling forward on the bar atop the
assembly (green lever guard marked "PULL"). .ig. Page 3-4
Apply the SATO Thermal Print Head and Platen Cleaner to one of the clean
wipes or a cotton swab.
With the dampened portion of the clean wipe or cotton swab, gently wipe
along the entire length of the platen. Make sure to rotate the platen so as
to clean its entire surface. (Note that the platen is the black rubber roller
directly below the print head.) .ig. Page 3-5
Repeat if necessary.
NOTE: The platen should be cleaned after every two rolls of printed
labels. Cleaning will ensure proper label movement through the printer.
SATO M-5900RV Operator and Technical Reference Manual
Section 3. Adjustments and Maintenance
PLATEN
Page 3-5