Entering A Call Channel Data; Entering A Channel Name - Icom ic-m423 Instruction Manual

4
BASIC OPERATION

■ Entering a Call channel data

You can enter data in Call channel in each channel group for
quick recall.
Select the desired channel group (INT, USA, CAN, ATIS,
q
or DSC) to be entered. (p. 12)
Hold down [16/C] for 1 second to select the Call channel of
w
the selected channel group.
• "CALL" and the Call channel number is displayed.
Hold down [16/C] again for 3 seconds (until a long beep
e
changes to 2 short beeps) to enter the Call channel entry
mode.
Rotate Dial or push [
r
Push [ENT] to save the displayed channel as the Call
t
channel.
• Push [CLEAR] to cancel.
16
∫]/[√] to select a channel.
Entering a Channel name
■
Enter a name of up to 10 characters.
Capital letters, 0 to 9, some symbols, (! " # $ % & ' ( ) * + , – .
/ [ \ ] ^ _ : ; < = > ?) and a space can be entered.
Push [ ∫]/[√](CH) to select a channel.
q
• First, cancel the Dualwatch, Tri-watch or Scan function, if acti-
vated.
Push [NAME] to open the channel name enter screen.
w
• A cursor is displayed on the first character.
Enter the desired channel name in the following manner:
e
• Select a desired character using Dial, or [∫]/[√]/[Ω]/[≈].
• Push [ENT] or Dial to set it.
• To move the cursor, select either arrow, "←" or "→," then push
[ENT] or Dial.
• Push [123], [!$?], or [ABC] to select a character group.
• Select "SPACE," then push [ENT] to enter a space.
• Select "DELETE," then push [ENT] to delete a character.
• Push [CLEAR] to cancel and return to the previous screen.