Table of Contents
Advertisement
– PMA35001-Y models meet the require-
ments of the EC Directives for electro-
magnetic compatibility and electrical
safety (refer to the chapter on
CE Marking)�
The area of use for the PMA35001-Y is
defined in the included documentation�
All restrictions listed in the included
documentation must be observed�
– Operating the PMA35001-Y beyond
the restrictions indicated is not permitted,
and is considered use of the equipment
for other than its intended purpose� Any
installation work that does not conform
to the instructions in this manual results
in forfeiture of all claims under the
manufacturer's warranty�
– If the equipment is modified by anyone
other than persons authorized by Sarto-
rius, authorization is withdrawn and all
claims under the manufacturer's warranty
are forfeited�
– The installation of the PMA35001-Y in
a hazardous area must be carried out by a
certified electrician�
A certified electrician is someone who is
familiar with the assembly, start-up and
operation of the system�
He is also familiar with all relevant
guidelines and regulations, and has the
required qualifications for performing the
installation� If you need assistance, con-
tact your Sartorius dealer or the Sartorius
Service Center�
– Avoid electrostatic charges� Connect
an equipotential bonding conductor�
Disconnecting equipotential bonding
conductors is not permitted� The location
is marked by a "ground" symbol�
The grounding cable must have a min�
cross section of 4mm
4
2
�
Connect all equipment, including periph-
eral devices, to the equipotential bonding
conductor�
– Do not expose the weighing instrument
to harsh chemical vapors or to extreme
temperatures, moisture, shocks, or vibra-
tion�
– The display values can be impacted when
subjected to extreme electromagnetic
influence�
When the negative influence has sub-
sided, the scale will again be fully
operational�
– The equipment must only be used
indoors�
– Make absolutely sure to disconnect the
scale from power (unplug the power
cord) before you connect or disconnect
a peripheral device (printer or PC) to or
from the interface port�
– If you use cables purchased from another
manufacturer, check the pin assignments
in the cable against those specified by
Sartorius before connecting the cable to
Sartorius equipment, and disconnect any
wires that are assigned differently� The
operator shall be solely responsible for
any damage or injuries that occur when
using cables not supplied by Sartorius�
– The power connection must be made in
accordance with the regulations appli-
cable in your country� If you need assis-
tance, contact your Sartorius dealer or
the Sartorius Service Center� Any instal-
lation work that does not conform to
the instructions in this manual results in
forfeiture of all claims under the manu-
facturer's warranty�
– To avoid generating static electricity
when using the dust cover:
The cover should only be cleaned using
a moist cloth�
Advertisement
Table of Contents
