Care And Maintenance; Tyre Pressure; Cleaning And Disinfection; Wiring Harness - Pride ELITE TRAVELLER PLUS Owner's Manual

I X . C A R E A N D M A I N T E N A N C E
Your Travel Scooter requires a minimal amount of care and maintenance. If you do not feel confident in your
ability to perform the maintenance listed below, you may schedule inspection and maintenance at your autho-
rised Pride Provider. The following areas require periodic inspection and/or care and maintenance.

TYRE PRESSURE

If equipped with pneumatic tyres, always maintain the psi/bar/kPa air pressure indicated on each tyre.
WARNING! It is important that the psi/bar/kPa air pressure indicated on each tyre be
maintained in pneumatic tyres at all times. Do not underinflate or overinflate your tyres.
Low pressure may result in loss of control, and overinflated tyres may burst. Failure to
maintain the psi/bar/kPa air pressure indicated on pneumatic tyres at all times may result
in tyre and/or wheel failure.
Regularly inspect your Travel Scooter's tyres for signs of wear.
EXTERIOR SURFACES
Bumpers, tyres, and trim can benefit from an occasional application of a rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the Travel Scooter's vinyl seat or
tyre tread. They will become dangerously slippery.

CLEANING AND DISINFECTION

Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your Travel
Scooter. Avoid using products that may scratch the surface of your Travel Scooter.
If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for
use on your product before application.
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or
cleaning agent before applying it to your product. Failure to comply may result in skin
irritation or premature deterioration of upholstery and/or Travel Scooter finishes.
BATTERY TERMINAL CONNECTIONS
Make certain that the terminal connections remain tight and are not corroded.
WIRING HARNESSES
Regularly check all wiring connections.
Regularly check all wiring insulation, including the charger power lead, for wear or damage.
Have your authorised Pride Provider repair or replace any damaged connector, connection, or insula-
tion that you find before using your Travel Scooter again.
PROHIBITED! Even though the Travel Scooter has passed the necessary testing
requirements for ingress of liquids, you should keep electrical connections away from
sources of dampness, including direct exposure to water or bodily fluids and
incontinence. Check electrical components frequently for signs of corrosion and replace
as necessary.
Elite Traveller Plus www.pridemobility.com
35