Download  Print this page

Care And Maintenance - Pride Icon Owner's Manual

Hide thumbs

Advertisement

I X . C A R E A N D M A I N T E N A N C E
Your scooter requires a minimal amount of care and maintenance. If you do not feel confident in your
ability to perform the maintenance listed below, you may schedule inspection and maintenance at your
authorised Pride Dealer. The following areas require periodic inspection and/or care and maintenance.
TYRE PRESSURE
! If equipped with pneumatic tyres, always maintain a proper 2-2.4 bar (30-35 psi) tyre pressure.
WARNING! It is important that 2-2.4 bar (30-35 psi) tyre pressure be maintained in
pneumatic tyres at all times. Do not underinflate or overinflate your tyres. Low pressure
may result in loss of control and overinflated tyres may burst. Failure to maintain 2-2.4
bar (30-35 psi) tyre pressure in pneumatic tyres at all times may result in tyre and/or
wheel failure, causing serious personal injury and/or damage to your scooter.
! Regularly inspect your scooter's tyres for signs of wear.
WHEEL REPLACEMENT
If your scooter is equipped with pneumatic tyres and you have a flat tyre, you can have the tube replaced. If
your scooter is equipped with a solid tyre insert, either the solid insert or the entire wheel must be replaced
depending on model. Contact your authorised Pride Dealer for information regarding replacement wheels
for your scooter.
WARNING! Prevent personal injury! Completely deflate pneumatic tyres before dismantling
the rim or attempting repair.
EXTERIOR SURFACES
Bumpers, tyres and trim can benefit from an occasional application of rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the scooter's vinyl seat, floorboard
or tyre tread. They will become dangerously slippery and result in personal injury and/or
damage to your scooter.
CLEANING AND DISINFECTION
! Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your scooter.
Avoid using products that may scratch the surface of your scooter.
! If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for
use on your product before application.
WARNING! Prevent personal injury and product damage! Follow all safety instructions for
the proper use of the disinfectant before applying it to your product.
BATTERY TERMINAL CONNECTIONS
! Make certain that the terminal connections remain tight and uncorroded.
! The batteries must sit flat in the battery wells.
! The battery terminals should face the rear of the scooter.
Icon
www.pridemobility.com
35

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: