Download  Print this page

Care And Maintenance; Tire Pressure; Cleaning And Disinfection - Pride MAXIMA-V Owner's Manual

Hide thumbs

Advertisement

Table of Contents
I X . C A R E A N D M A I N T E N A N C E
Your scooter requires a minimal amount of care and maintenance. If you do not feel confident in your
ability to perform the maintenance listed below, you may schedule inspection and maintenance at your
authorized Pride Provider. The following areas require periodic inspection and/or care and maintenance.

TIRE PRESSURE

If equipped with pneumatic tires, always maintain the psi/bar/kPa air pressure rating indicated on each tire.
WARNING! It is critically important that the psi/bar/kPa air pressure rating be maintained
in pneumatic tires at all times. Do not underinflate or overinflate your tires. Low pressure
may result in loss of control and overinflated tires may burst. Failure to maintain the psi/
bar/kPa air pressure rating indicated on pneumatic tires at all times may result in tire
and/or wheel failure.
Regularly inspect your scooter's tires for signs of wear.
EXTERIOR SURFACES
Bumpers, tires, and trim can benefit from an occasional application of rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the scooter's vinyl seat, floorboard,
or tire tread, as they will become dangerously slippery.

CLEANING AND DISINFECTION

Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your scooter.
Avoid using products that may scratch the surface of your scooter.
If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for
use on your product before application.
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or
cleaning agent before applying it to your product. Failure to comply may result in skin
irritation or premature deterioration of upholstery and/or scooter finishes.
BATTERY TERMINAL CONNECTIONS
Make certain that the terminal connections remain tight and uncorroded.
The batteries must sit flat in the battery wells.
The battery terminals should face the rear of the scooter.
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY
These items are all prelubricated, sealed, and require no subsequent lubrication.
MOTOR BRUSHES
The motor brushes are housed inside of the motor transaxle/assembly. They should be inspected periodi-
cally for wear by your authorized Pride Provider.
CONSOLE, CHARGER AND REAR ELECTRONICS
Keep these areas away from moisture.
Before operating your scooter, allow any of these areas to dry thoroughly if they have been exposed to moisture.
34
www.pridemobility.com
Maxima-V

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: