I X . C A R E A N D M A I N T E N A N C E
The motor brushes are housed inside of the motor/transaxle assembly. They should be inspected periodi-
cally for wear by your authorised Pride Provider.
CONSOLE, CHARGER, AND REAR ELECTRONICS
Keep these areas free of moisture.
Allow these areas to dry thoroughly if they have been exposed to moisture before operating your
Travel Scooter again.
NYLON LOCK NUT REPLACEMENT
Any nylon insert lock nut removed during the periodic maintenance, assembly, or disassembly of the
Travel Scooter must be replaced with a new nut. Nylon insert lock nuts should not be reused as it may
cause damage to the nylon insert, resulting in a less secure fit. Replacement nylon insert lock nuts are
available at local hardware stores or through your authorised Pride Provider.
STORING YOUR TRAVEL SCOOTER
If you plan on not using your Travel Scooter for an extended period of time, it is best to:
1. Fully charge its batteries prior to storage.
2. Remove the battery pack from the Travel Scooter.
3. Store your Travel Scooter in a warm, dry environment.
4. Avoid storing your Travel Scooter where it will be exposed to temperature extremes.
WARNING! Always protect batteries from freezing temperatures and never charge a
Batteries that are regularly and deeply discharged, infrequently charged, stored in extreme temperatures,
or stored without a full charge may be permanently damaged, causing unreliable performance and limited
service life. It is recommended that you charge the Travel Scooter batteries periodically throughout peri-
ods of prolonged storage to ensure proper performance.
For prolonged storage, you may wish to place several boards under the frame of your Travel Scooter to
raise it off of the ground. This takes the weight off the tyres and reduces the possibility of flat spots
developing on the areas of the tyres contacting the ground.
DISPOSAL OF YOUR TRAVEL SCOOTER
Your Travel Scooter must be disposed of according to applicable local and national statutory regulations.
Contact your local waste disposal agency or authorised Pride Provider for information on proper disposal
of packaging, metal frame components, plastic components, electronics, batteries, neoprene, silicone, and
Elite Traveller Plus