Timeouts; Vad - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Voice and Video Volume)
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
26 Confidential and Proprietary Information of ZTE CORPORATION

timeouts

Use this command to configure the time interval between the voice
port and dial-up. Restore the default with the no command.
Voice port configuration
timeouts {call-dead | call-disconnect | initial | interdigit}<s
econds>
no timeouts {call-dead | call-disconnect | initial | interdigit}
call-dead <seconds>
call-disconnect
<seconds>
initial <seconds>
interdigit <seconds>
� The modified voice port configuration will take effect in the next
dial-up.
� It is only applied to ZXR10 GAR and ZXR10 ZSR.

vad

Use this command to enable the mute detection function. Disable
the mute detection function with the no command.
Voice port configuration

vad

no vad
If this area is configured, it is disabled by default.
� The modified voice port configuration will take effect in the next
dial-up.
� It is only applied to ZXR10 GAR and ZXR10 ZSR.
This example describes how to enable the mute detection function
on port voice_3/1.
ZXR10(config)#voice-port voice_3/1
ZXR10(config-voice-port)#vad
Configures the unallocated number play time
(unit: second), in the range of 1~120, 60
seconds by default
Configures the timeout time of the howler
tone sent to the caller (unit: second), in the
range of 1~120, 60 seconds by default
Configure the timeout time from offhook to
the first dial-up number (unit: second), in the
range of 1~60, 10 seconds by default
Configure the timeout time in the interval of
dialing two numbers (unit: second), in the
range of 1~60, 10 seconds by default