Rewind Assembly - Datamax I-class Maintenance Manual

Hide thumbs Also See for I-class:

Table of Contents

Removal and Replacement

Replacement:

1. Reinstall the Outer Bearing in the Thermal Transfer Housing.

2. Position the Take-Up Hub Clutch in the Thermal Transfer Housing

3. Slide the Take-Up Hub shaft through the Take-Up Hub Clutch and Thermal Transfer Housing.

4. Reinstall the Inner Bearing and clip the E-Ring onto the Take-Up Hub shaft.

5. Reinstall the Thermal Transfer Assembly; see Section 4.5.

4.6 Rewind Assembly

Removal:

1. Turn OFF and unplug the printer. Raise the cover.

2. Remove the three Screws that secure the Rewind Assembly to the Centerplate then remove the

Rewind Assembly.

4-17

Table of Contents

Table of Contents

Do you have a question about the I-class and is the answer not in the manual?