Cleaning The Media Path, Media Sensor, And Interior - Datamax I-class Maintenance Manual

Hide thumbs Also See for I-class:

Table of Contents

4. Install media then lower and latch the Printhead Assembly.

5. Close the cover. Plug in and turn ON the printer. Feed several labels to normalize tracking.

2.4.3

Cleaning the Media Path, Media Sensor, and Interior

As paper dust and other contaminants accumulate inside the printer, the particles can be pulled

through the Media Sensor to the printhead, causing inconsistent label detection and voids in the print.

To prevent problems, clean Media Path, Media Sensor and other components as follows:

1. Turn OFF and unplug the printer. Raise the cover.

2. Raise the Printhead Assembly then remove the media (and ribbon, if installed).

Tear Bar

Rewind Plate

Media Sensor

Media Guide

Adjustments and Maintenance

Media Idler

2-19

Baseplate

Table of Contents

Table of Contents

Do you have a question about the I-class and is the answer not in the manual?