Emerson SmartCabinet User Manual page 83

As for the operation method of the three tabs of Sampling, Setting and Alarm on the Monitoring unit page, refer to
6.4.1 Cabinet Data.
Note
On the Setting tab, if you set 'Blocked' for Outgoing Alarm Blocked, when an alarm occurs, it will be blocked, in this case:
1. For current alarms, the page only displays the alarm signals, but not send alarm notifications; after the alarm disappears, it will
not be saved in history alarm;
2. The 'Blocked' setting for Outgoing Alarm Blocked will be automatically cleared in 24h.
Network Setting
1. IP Setting
Click the Network Setting submenu under the System Options menu, the page shown in Figure 6-52 pops up.
On the page shown in Figure 6-52, you can configure the network parameters, such as IP addressing mode, IP,
Mask, Default Gateway, DNS1 (Preferred DNS server) and DNS2 (Alternate DNS server). After modifying the
network parameters, click the Save button to make the setting effective.
Note
After modifying the IP address, the system will jump to the new IP address by default. You must use the new IP address to
re-login the MSC-C.
2. Access Management
Click the Network Setting submenu under the System Options menu, and then click the Access Management tab,
the page shown in Figure 6-53 pops up.
Figure 6-51 Monitoring unit (Sampling)
Figure 6-52 IP setting
SmartCabinet Integrated Solution User Manual
Chapter 6 Web Page Of MSC-C 79