Installing Ups Power Supply System; Installing Battery Module - Emerson SmartCabinet User Manual

Note
1. The AC refrigerant is R410A. The low quality or counterfeit refrigerant will damage the system severely. Please use the
refrigerant approved by Emerson Network Power Co., Ltd. For the system abnormity or damage caused by using other brands of
refrigerant, the warranty will be invalid.
2. After engineering installation is finished, before start up the device, please ensure that the connected pipes are all installed
without leakage. You need to apply sealant to the unit pipe outlets for sealing.

3.3 Installing UPS Power Supply System

The system is configured with Emerson ITA series 5kVA UPS and battery. The UPS is rack-mounted in the U space
at lower part of the cabinet, it cooperates with the power management unit (PMU for short, it has been installed at top
part of the cabinet) installed in the same cabinet to realize mains input and power supply and distribution
management function. There are two versions for the UPS configured in the system: domestic version and
Asia-Pacific LCD version. For Asia-Pacific version, the UPS and the battery module are installed in the SmartCabinet
at factory and delivered with the cabinet; for domestic version, the UPS needs to be installed in user field. The
following introduces how to install the battery and the UPS of domestic version.

3.3.1 Installing Battery Module

1. Use six M4 × 10 screws to fix two hangers (accessories) onto both sides of the front panel of the battery module,
as shown in Figure 3-10.
2. Place the battery module on the cabinet bracket, push it in and use four M6 × 16 screws to fix it on the rack, as
shown in Figure 3-11.
A
Figure 3-9 Condensate water pipe location
Screw (6 pcs)
Figure 3-10 Installing brackets
SmartCabinet Integrated Solution User Manual
Chapter 3 Installation
Drain pipe
Hose barb
A amplified
Battery module
Hanger (2 pcs)
19