Emerson SmartCabinet User Manual page 29

Chapter 3 Installation 25
2) The other IRM-S01T temperature sensor installed with magnet has already been installed on the labeled position
on the left cable trough on rear door of the cabinet, as shown in Figure 3-20.
2. Install 4DIF sensor
The IRM-S04DIF sensor installed with magnet has already been installed on the cable holder on rear door of the
cabinet, as shown in Figure 3-20.
4DIF sensor
Temperature
sensor
Figure 3-20 Installing temperature sensor and 4DIF sensor
3. Install water leakage sensor
1) Open the rear door of the empty cabinet, stick the water leakage sensor onto the lower part of the cable organizer.
2) Connect the water leakage detective belt, lead and fasten the detective belt properly with the provided cable tie
fixture kits.
3) Lay the detective belt at the bottom of the cabinet, as shown in Figure 3-21.
Water
leakage
sensor
SmartCabinet Integrated Solution User Manual