Installing Sensors - Emerson SmartCabinet User Manual

24 Chapter 3 Installation
Working mode
Maintanence mode
Normal mode
Reset mode
The jumper setting of the MSC-C card is normal mode by default.
The MSC-C card inserter is used to insert the MSC-C card into the intellislot intelligent card slot of the UPS. Use
screws to tighten it, as shown in Figure 3-18.

3.6.3 Installing Sensors

Note
For the detailed installation guide of the sensors, refer to IRM-S01T Intelligent Temperature Sensor User Manual, IRM-S04DIF
Intelligent Digital Input Sensor With RJ45 Ports User Manual, IRM-S01W Water Leakage Detective Belt Sensor User Manual
and G Net EDGE Wireless Network Card With USB Port User Manual.
1. Install temperature sensor
1) Stick an IRM-S01T temperature sensor installed with magnet onto the middle part (an indication label is pasted) of
the front right vertical pole of the cabinet, as shown in Figure 3-19.
Table 3-7 Jumper setting of the MSC-C card
Jumper setting
J20 J18
J20 J18
J18
Intelligent card slot
Figure 3-18 Schematic diagram of installing MSC-C card
Figure 3-19 Installing temperature sensor of front door
SmartCabinet Integrated Solution User Manual
The USB port is used to login the MSC-C card through Hyper
Terminal (TTY) or Remote Login (Telnet)
The USB port is used to connect to the SMS module
When you forget the password of 'rduadmin', password of Web
system administrator 'admin' and IP address, set the jumpers
according to this mode, reboot the MSC-C card, and wait more than
20s to recover the above three parameters to be default values
Baffle plate of
intelligent card slot
Description
MSC-C intelligent card
Temperature
sensor