Notes - Emerson SmartCabinet User Manual

The appearance of the MSC-C card is shown in Figure 3-16.
MSC-C card inserter
Connected component
Port connecting to node
Note*: The intelligent devices all connect to COM2 of MSC-C, and the device number in serial connection cannot exceed 8pcs

3.6.2 Notes

When installing MSC-C, take the following precautions to avoid personnel injury and device damage by accident.
Always cut off the power before performing any installation operation on the MSC-C
Ensure that the external devices are connected to the correct MSC-C ports
Wear an ESD wrist-wrap during installation
Arrange the wires properly, and do not put any heavy objects on the wires or stamp the wires
Make sure that the jumpers of MSC-C card are set to correct position. The jumper locations are shown in Figure 3-17.
See Table 3-7 for the jumper setting of the MSC-C card.
Front panel
Figure 3-16 Appearance of the MSC-C card
Table 3-6 Performance specifications
Cable standard
Twisted pair cable of
standard category 4
Figure 3-17 Jumper locations of the MSC-C card
SmartCabinet Integrated Solution User Manual
RUN indicator COM1 port
Network port USB port
Connected distance (unit: m)
100
J18 jumper
location
J20 jumper
location
Chapter 3 Installation
COM2 port Front panel
Connected number /
connected point
8*
23