Liebert 130 kVA User Manual page 55

User Manual
Hipulse - Single Phase '1+N' UPS System
>MEASUREMENT >MEASUREMENT
FUNCTION FUNCTION
MAINTENANCE MAINTENANCE
SETUP SETUP
OUTPUT OUTPUT
INPUT INPUT
>BATTERY >BATTERY
TEMPERATURE TEMPERATURE
BATTERY BATTERY
VOLTAGE VOLTAGE 446 [V] 446 [V]
CURRENT CURRENT 001 [A] 001 [A]
CHARGE CHARGE
NORMAL OPERATION NORMAL OPERATION
hh.mm.ss hh.mm.ss dd.mm.yy dd.mm.yy
NORMAL OPERATION NORMAL OPERATION
(ECOMODE) (ECOMODE)
hh.mm.ss hh.mm.ss dd.mm.yy dd.mm.yy
< <
Select MEASUREMENT and press ENTER key.
Select BATTERY and d.c. busbar voltage will be
displayed:
< <
If the voltage indicated is satisfactory (432V d.c. for
380V a.c. system, 446VV d.c. for 400V a.c. system
and 459V d.c. for a 415V a.c. system) press the
Escape key repeatedly until the display returns to
000 [%] 000 [%]
the original window.
6. Manually close the battery circuit breaker. This
is located inside the battery cabinet (if used) or is
otherwise located adjacent to the battery racks.
The Module Mimic indicator (3) Battery unavailable
should extinguish.
state of charge bargraph
showing the battery state of charge
When the battery circuit breaker has been closed
and the inverter has stabilized the screen will
change to the default window.
Default window:
The message shown below, will be seen on the
default screen whenever the UPS is operating
normally:
The top lines display the UPS operational status
and indicates alarm conditions when they occur;
and line four normally shows the time and date.
ECOMODE:
The following message will appear in the default
screen
ECOMODE. The load is supplied through Bypass
Mains.
The UPS is operating in ECOMODE with the Bypass
35
Several LED's on the Battery
(17) will illuminate
The UPS is operating normally with its
Inverter supplying the load.
whenever the UPS
Mains supplying the load.
130 kVA - 110V
is operating in