Connecting To The Mains Power Supply; Disconnecting Cables - Wincor Nixdorf BEETLE/S User Manual

BEFORE SWITCHING ON THE SYSTEM

Connecting to the mains power supply

All devices belonging to the modular BEETLE /S system that have a
separate power cable must be connected to the same electric circuit.
Make sure that all data cables on the system unit and peripherals are
connected correctly.
Plug all power cables belonging to the BEETLE and the peripherals into the
grounded-contact power sockets.
You can now switch on the BEETLE /S by means of the switch on the
power supply at the rear side. Push the ON/OFF button at the front of the
box.
The power supply can be connected to all standard power supply networks.
The unit adjusts automatically to the respective voltage. The exhaust of the
power pack provides for the necessary cooling. The maximum output of the
power pack is 150 W.

Disconnecting cables

Never unplug a cable by pulling on the cable itself; always take hold of the
actual plug. Follow the procedure below when disconnecting cables:
Turn off all power and equipment switches.
n
n Remove the cable cover.
Unplug all data communication cables from the sockets of the data
n
networks.
Unplug all power plugs from the grounded-contact power sockets.
n
Unplug all cables from the devices.
n
12
With MINI-DIN plugs, the plug remains inserted
until released.
Pull the plastic covering from the connecting
socket with your thumb. The lock is released.
The metal of the plug is visible.
RJ12 plugs lock in when you insert them. To
release them push the latch under the plug to
the top.