Connecting To The Mains Power Supply - Wincor Nixdorf BEETLE /XS User Manual

BEFORE SWITCHING ON THE SYSTEM

Connecting to the mains power supply

All devices belonging to the modular BEETLE /XS system that have a
separate power cable must be connected to the same electric circuit.
Make sure that all data cables on the system unit and peripherals are
n
connected correctly.
Plug all power cables belonging to the BEETLE and the peripherals into
n
the grounded-contact power sockets.
mains connector
You can now switch on the BEETLE /XS by pushing the ON/OFF button at
the front of the box. Pushing the button again will lead to a standby mode.
To disconnect the device from the supply voltage completely, disconnect
the power plug.
115V
230V
14
LPT1
MIC
KYBD COM1*
USB
ON/OFF button
The power supply can be connected to all
standard power supply networks.
The unit must be adjusted to the respective
voltage by means of the switch next to the
mains connector.
The maximum output of the power pack is
120 W.
SPK
COM2* LAN/ASYN