Advanced Settings - NETGEAR PS113 Installation Manual

Note: The PS110/PS113 Print Server, by default, automatically obtains an IP
address from the network. However, NETGEAR recommends you use a fixed IP
address to be able to use a Web browser to print a test page or to make
configuration changes later. For a home or small office, use IP address information
compatible with your router setup. The IP address for the print server needs to be
unique in the network. If you don't know what to use, you may click
to get a useable IP address. If you are using a NETGEAR router with default
Values
settings, the following settings should work: IP address: 192.168.0.150 (The first
three numbers should match the numbers for the network device. Make sure the
last 3 digits are unique on your network.)
Subnet mask: 255.255.255.0
Gateway IP address: 192.168.0.1 (the address of your router)
3. When complete, click
4. When asked if you want to set up a printer right away, click
procedure 4: Configure a Computer To Access the Print Server. You have already completed
the software installation and are running the NETGEAR Add Printer Wizard.

Advanced Settings

Advanced users may want to change the default name of the Print Server or make other
changes in the settings. There are 2 ways to administer your NETGEAR Print Server. The
Reference Manual on the Resource CD has full instructions.
a. Open a Web browser and go to the IP address for the print server. (For example, type
http://192.168.0.150 and click
b. You can use the NETGEAR Print Server Administration program. Click
and click
Programs
6
.
Finish
) or
Go
NETGEAR Print Server>NETGEAR Print Server Administration
Suggest New
and continue to
Yes
. Point to
Start
.