Diagnostic/Reset Push Button; How To Restore The Factory Default Settings; How To Generate A Diagnostic Printout - NETGEAR PS121v2 User Manual

Usb multifunction printer server

Hide thumbs Also See for PS121v2:

Table of Contents

NETGEAR USB Multifunction Printer Server PS121v2 User Manual

Diagnostic/Reset Push Button

This button has 2 functions:

•

Restore the factory default settings

•

Print a test page containing all current settings

Recessed Diagnostic/Reset Button

Figure 1-4

The button is recessed. Use a pin or paper clip to press it.

1. Unplug the Print Server from its power source.

2. Press and hold the diagnostic button. While pressing the button, apply power to the Print

Server and continue pressing the button until the ACT and ERROR LEDs flash alternately.

Note: PostScript printers are unable to print this page. If you have a PostScript printer, the

test page will not be printed.

1. Ensure that both the Print Server and the attached printer are on.

2. Press the diagnostic button, and hold it in until the ERROR LED flashes slowly.

3. The test page, containing the current settings, will print.

1-6

v1.1, September 2006

Introduction

Table of Contents