Chapter 5 Using Advanced Management Tools; Configuration Using The Netgear Print Server Administration Program - NETGEAR PS101 Reference Manual

NetGear Print Server Manual
Chapter 5
This chapter describes in more detail the two print server management programs bundled with
NETGEAR PS100 series print servers. These programs are included on the Print Server Resource CD.
The two programs are for advanced users and described in this chapter are:
• NETGEAR Print Server Administration Program
This software program is a print server administration program based on Windows 95,
Windows 98, Windows NT, Windows XP, or Windows 2000. It runs on TCP/IP and Netbios
protocols that the print server supports.
• IPSetup
This program is to setup the IP address of the Print Server manually from Microsoft Windows.
Use this handy tool to set up the IP address for the print server when there are troubles to get IP
information from the print server.
5-1 Configuration Using the NETGEAR Print Server Administration
Program
Before you begin this section, you must first install the NETGEAR Print Server software on your PC,
using the supplied CD-ROM.
To start the NetGear Administration Program:
• Click on Start
• Move along the program folders to highlight the NetGear program folder
• Click on the icon for the Print Server Administration program
As illustrated below, the main screen of the NetGear print server setup utility opens and searches the
network for NETGEAR print servers.
All active NETGEAR print servers are listed on the screen as shown. If there is any print server
missing from the screen, you may click on the Browse button to scan the network one more time. By
Using Advanced Management Tools
NETGEAR Print Server Administration Program
37