Advanced Settings - NETGEAR PS101 Installation Manual

Note: The PS101 Print Server, by default, automatically obtains an IP address from
the network. However, NETGEAR recommends you use a fixed IP address to be
able to use a Web browser to print a test page or to make configuration changes
later. For a home or small office, use IP address information compatible with your
router setup. The IP address for the print server needs to be unique in the network.
If you don't know what to use, you may click Suggest New Values to get a useable
IP address. If you are using a NETGEAR router with default settings, the following
settings should work:
IP address: 192.168.0.150 (The first three numbers should match the
numbers for the network device. Make sure the last 3 digits are unique
on your network.)
Subnet mask: 255.255.255.0
Gateway IP address: 192.168.0.1 (the address of your router)
3. When complete, click
4. When asked if you want to set up a printer right away, click
procedure 4: Confirgure a Computer To Access the Print Server. You have already completed
the software installation and are running the NETGEAR Add Printer Wizard.

Advanced Settings

Advanced users may want to change the default name of the Print Server or make other
changes in the settings. There are 2 ways to administer your NETGEAR Print Server. The
Reference Manual on the Resource CD has full instructions.
a. Open a Web browser and go to the IP address for the print server. (For example, type
http://192.168.0.150 and click
b. You can use the NETGEAR Print Server Administration program. Click
and click
Programs
Finish.
.) or
Go
NETGEAR Print Server>NETGEAR Print Server Administration
and continue to
Yes
. Point to
Start
.
5