Cleaning And Maintenance; General Advice; Enamelled Parts - Elba P60 Instructions For The Use - Installation Advices

3

CLEANING AND MAINTENANCE

GENERAL ADVICE

Before you begin cleaning you must ensure that the hob is switched off.
It is advisable to clean when the appliance is cold and especially when cleaning the

enamelled parts.

All enamelled surfaces have to be washed with soapy water or some other non-abra-
sive product with a sponge and are to be dried preferably with a soft cloth.
Avoid leaving alkaline or acid substances (lemon juice, vinegar etc.) on the surfaces.
Do not use cleaning products with a chlorine or acidic base.
WARNING
When correctly installed, your product meets all safety requirements laid down for
this type of product category. However special care should be taken around the
underneath of the appliance as this area is not designed or intended to be
touched and may contain sharp or rough edges, that may cause injury.
ENAMELLED PARTS
All the enamelled parts must be cleaned with a sponge and soapy water only or other
non-abrasive products.
Dry preferably with a microfibre or soft cloth.
If acid substances such as lemon juice, tomato conserve, vinegar etc. are left on the
enamel for a long time they will etch it, making it opaque.
STAINLESS STEEL ELEMENTS
Stainless steel parts must be rinsed with water and dried with a soft and clean cloth.
For persistent dirt, use specific non-abrasive products available commercially or a lit-
tle hot vinegar.
Attention
The appliance gets very hot, mainly around the cooking areas. It is very impor-
tant that children are not left alone in the kitchen when you are cooking.
Do not use a steam cleaner because the moisture can get into the appliance
thus make it unsafe.
9