Table of Contents
Advertisement
3
CLEANING AND MAINTENANCE
GLASS LID - optional
INSTALLATION OF THE GLASS LID
1.
Remove gently the 2 hole-cover plates (T) from the rear edge of the cooking hob,
being careful not to chip the enamel (fig. 3.2).
Thread the 4 holes (H) with the screws (F) (fig. 3.1). Lubricate the screws with an oil
2.
drop to make easy the screwing.
Insert the gaskets (G) under each hinge support (fig. 3.1).
3.
4.
House the right and left (B) hinge supports, then fasten by the screws (F).
Slip on the hinges on the side housings of the rear profile.
5.
IMPORTANT: in the right housing werhave to insert the hinge marked "D", while in the
left housing we have to insert the hinge marked "S".
6.
Assemble the lid by inserting the hinges on the two supports.
Fig. 3.1
S
B
G
28
F
H
D
F
B
H
G
Advertisement
Table of Contents
