Elba P60 Instructions For The Use - Installation Advices page 13

FASTENING THE
INSTALLATION BRACKETS
(figs. 4.4, 4.5, 4.6)
Each cooker top is provided with an
installation kit including brackets and
screws for fastening the top to fixture
panels from 2 to 4 cm thick.
Turn the cooker top upside down and
fasten the brackets "F and R" to the
appropriate socket holes, without
tightening the screws "B" for the
moment.
Make sure that the brackets are fas-
tened as shown in figure 4.4.
R
Rear side
D
R
Fig. 4.4
R
C
B
Fig. 4.5
FASTENING THE COOKER
TOP
(figs. 4.5 and 4.6)
Spread the sealing material "D" out
along the fixture hole, making sure
that the junctions overlap at the cor-
ners.
Insert the cooker top into the hole
and position it correctly.
Adjust the position of the brackets "F
and R"; tooth C of the tabs should go
into the hole. Tighten screws "B" to
block the cooker top firmly in posi-
tion.
With a sharp cutter or trimmer knife
trim the excess sealing material
around the edge of the cooker top.
Take care not to damage the bench-
top.
F
F
Front side
C
B
Fig. 4.6
D
F
13