Operating Storage Enclosures; Turning The Power On - Silicon Graphics Total Performance 9300 User Manual

3.

Turning the Power On

007-4644-001
Chapter 3

Operating Storage Enclosures

This chapter describes the operation of the storage enclosures in the following sections:
• "Turning the Power On" on page 27
• "Turning the Power On after an Unexpected Shutdown" on page 29
• "Turning the Power Off" on page 32
• "Monitoring Status with Software" on page 33
• "Checking the Indicator Lights" on page 34
• "Moving the Enclosure" on page 40
Note: All of the procedures in this chapter apply to both the controller enclosures and
the expansion enclosures.
If the storage enclosure was turned off due to an unexpected shutdown or a power
failure, follow the instructions in "Turning the Power On after an Unexpected
Shutdown" on page 29.
Danger:
Severe electrical shock can occur. Never turn on the power to any
equipment when there is evidence of fire, water, or structural damage. If there is
evidence of damage, call the factory or appropriate service organization for assistance.
Depending on the current service agreements, you may need to send the unit back to
the factory for repair/replacement.
27